High Voltage
Overhead power cables are an example of a power source generating high voltage electricity. High voltage electricity has the ability to 'jump' or 'arc' up to distances of 18 metres or more. If faced with a casualty as a result of, or in the vicinity of, dangerous high voltage electricity, DO NOT APPROACH! Stay at least 25 metres away from the casualty until the power has been switched off by an official agency i.e. the Electricity Board.
Low Voltage
If faced with a casualty who is in the process of receiving a low voltage electric shock you should:
- Act to break the contact between the casualty and the electrical supply. If possible to do so safely, you should turn off the source of electricity, either by switching off the current at the mains, turning the power off at the circuit board, removing the plug or wrenching the cable free.
- Alternatively, move the source of the shock (i.e. hairdryer, power tool) away from yourself and the casualty using an object of low conductivity. First, stand on a dry insulating material, such as a book, newspapers or rubber matting. Then, use a long, low-conductivity object like a wooden broom or specially designed Electric Shock Rescue Hook to push the power source away from the casualty or move the casualty's limbs away from the power source.
- Check whether the casualty is concious:
If the casualty is responsive, call emergency services now.
Then, check for breathing as follows:
1. LOOK for the rise and fall of the chest.
2. LISTEN for the sounds of breathing.
3. FEEL for air on your cheek 4. Carry this out for up to 10 seconds
If the casualty is breathing, put them into the recovery position (see section 6) and then call 999 for emergency help. Continually monitor and record vital signs - breathing, pulse and responsiveness - until help arrives.
If the casualty is not breathing normally:
1. Ask a helper to call 999 for an ambulance and then to bring an AED if available. If you are alone, make the call yourself.
2. Begin CPR with chest compressions as soon as possible. Do not leave the casualty to search for an AED.
When phoning emergency services, DO NOT hang up at any stage of the conversation. The operator will terminate the call when appropriate. You should determine responsiveness and whether the casualty is breathing before speaking to the emergency services because this enables them to assign the appropriate priority to your situation.
1. Ensure the casualty is lying on their back on a firm, flat surface 2. Place your hands one on top of the other in the centre of the casualty's chest 3. Compress the chest (up to a maximum depth of approximately 4-5cm) 30 times at a rate of 100-120 compressions per minute. The compressions and releases should take an equal amount of time 4. After 30 compressions, open the airway again using the head tilt/chin lift 5. Seal the nostrils with your thumb and forefinger 6. Blow steadily into the mouth until you see the chest rise. This should take about a second. If available, it is advisable you use resuscitation equipment, such as a face shield. 7. Remove your mouth to the side and let the chest fall. Inhale some fresh air and repeat these steps so you have given 2 effective rescue breaths in total. 8. If the chest does not rise after the second breath, go back to 30 compressions and then try again with 2 breaths. 9. Return your hands to the correct position on the chest and give a 30 chest compressions.
Continue giving CPR at a ratio of 30 compressions followed by 2 rescue breaths until:
- The casualty shows signs of recovery
- Emergency services arrive
- The situation changes and you are now in immediate danger
4. Place the nearest arm at a right angle to the body
5. Draw the furthest arm across the chest and place the back of the hand across the cheek nearest to you
6. Keep this here whilst you raise the furthest leg by grasping the top of the knee 7. Gently pull on the knee so the casualty pivots over onto their side facing you 8. The casualty should be fully onto their side and stable 9. Adjust the upper leg so the hip and the knee are bent at right angles 10. Re-check the airway, breathing and circulation. Ensure the airway is open 11. Check for continued breathing 12. Ask someone to call 999 if not done already. If you are alone, do so yourself. Leave the casualty if necessary but return as soon as possible.
Click here for a NHS video on the recovery position.
For responsive casualties:
- Cool burns for a minimum of 10 minutes under cold water
- Cool the burn with wet dressings (or special burn dressings) after placing them in the recovery position.
- Burst any blisters
- Apply adhesive dressings
- Remove damaged skin
- Apply ointments/creams
- Cover with 'fluffy' dressings
- Affix dressings too tightly
- Apply butter/fats/margarine or other substances commonly believed to cool burns
- Remove damaged clothing
- Apply ice
If no injury is present and the casualty appears well, it is still advisable to take the casualty to a hospital or medical facility for a check-up, as certain organs/systems within the body may be affected several hours after a shock.
An electric shock guidance poster is available to buy, helping to raise safety awareness throughout your organisation. The Electric Shock poster has clear, step by step instructions on how to react in case of an electric shock and how to provide treatment to someone that has been electrocuted. The poster is designed for both first aiders and non-first aiders providing them with the essential first aid and safety information. We have a range of products available to assist with the rescue and first aid treatment of someone who has received an electric shock. This article is not intended as a substitute for first aid training.