The Physics: A prism works because the different colors of light travel at different speeds inside the glass. Because the colors of light travel at different speeds, they get bent by different amounts and come out all spread out instead of mixed up. Violet travels the slowest so it is on the bottom and red travels the fastest so is on the top. This is because what is called the index of refraction, (the ratio of the speed of light in a vacuum to the speed of light in a material), is increased for the slower moving waves (i.e. violet). The higher index of refraction means that violet light is the most bent, and red is then the least bent because of its lower index of refraction, and the other colors fall somewhere in between. When the air is full of water, like after a rainstorm, the water droplets act like a prism and can make a rainbow. Rainbows are circular in shape because the prisms (raindrops) that created them are spherical.  Summary
Everyone enjoys the spectacle of a rainbow glimmering against a dark stormy sky. How does sunlight falling on clear drops of rain get broken into the rainbow of colors we see? The same process causes white light to be broken into colors by a clear glass prism or a diamond. (See Figure 1.) We see about six colors in a rainbow—red, orange, yellow, green, blue, and violet; sometimes indigo is listed, too. Those colors are associated with different wavelengths of light, as shown in Figure 2. When our eye receives pure-wavelength light, we tend to see only one of the six colors, depending on wavelength. The thousands of other hues we can sense in other situations are our eye’s response to various mixtures of wavelengths. White light, in particular, is a fairly uniform mixture of all visible wavelengths. Sunlight, considered to be white, actually appears to be a bit yellow because of its mixture of wavelengths, but it does contain all visible wavelengths. The sequence of colors in rainbows is the same sequence as the colors plotted versus wavelength in Figure 2. What this implies is that white light is spread out according to wavelength in a rainbow. Dispersion is defined as the spreading of white light into its full spectrum of wavelengths. More technically, dispersion occurs whenever there is a process that changes the direction of light in a manner that depends on wavelength. Dispersion, as a general phenomenon, can occur for any type of wave and always involves wavelength-dependent processes.
Dispersion is defined to be the spreading of white light into its full spectrum of wavelengths. Refraction is responsible for dispersion in rainbows and many other situations. The angle of refraction depends on the index of refraction, as we saw in Chapter 25.3 The Law of Refraction. We know that the index of refraction [latex]\boldsymbol{n}[/latex] depends on the medium. But for a given medium, [latex]\boldsymbol{n}[/latex] also depends on wavelength. (See Table 2. Note that, for a given medium, [latex]\boldsymbol{n}[/latex] increases as wavelength decreases and is greatest for violet light. Thus violet light is bent more than red light, as shown for a prism in Figure 3(b), and the light is dispersed into the same sequence of wavelengths as seen in Figure 1 and Figure 2.
Any type of wave can exhibit dispersion. Sound waves, all types of electromagnetic waves, and water waves can be dispersed according to wavelength. Dispersion occurs whenever the speed of propagation depends on wavelength, thus separating and spreading out various wavelengths. Dispersion may require special circumstances and can result in spectacular displays such as in the production of a rainbow. This is also true for sound, since all frequencies ordinarily travel at the same speed. If you listen to sound through a long tube, such as a vacuum cleaner hose, you can easily hear it is dispersed by interaction with the tube. Dispersion, in fact, can reveal a great deal about what the wave has encountered that disperses its wavelengths. The dispersion of electromagnetic radiation from outer space, for example, has revealed much about what exists between the stars—the so-called empty space.
Rainbows are produced by a combination of refraction and reflection. You may have noticed that you see a rainbow only when you look away from the sun. Light enters a drop of water and is reflected from the back of the drop, as shown in Figure 4. The light is refracted both as it enters and as it leaves the drop. Since the index of refraction of water varies with wavelength, the light is dispersed, and a rainbow is observed, as shown in Figure 5 (a). (There is no dispersion caused by reflection at the back surface, since the law of reflection does not depend on wavelength.) The actual rainbow of colors seen by an observer depends on the myriad of rays being refracted and reflected toward the observer’s eyes from numerous drops of water. The effect is most spectacular when the background is dark, as in stormy weather, but can also be observed in waterfalls and lawn sprinklers. The arc of a rainbow comes from the need to be looking at a specific angle relative to the direction of the sun, as illustrated in Figure 5 (b). (If there are two reflections of light within the water drop, another “secondary” rainbow is produced. This rare event produces an arc that lies above the primary rainbow arc—see Figure 5 (c).)
Rainbows are produced by a combination of refraction and reflection. Dispersion may produce beautiful rainbows, but it can cause problems in optical systems. White light used to transmit messages in a fiber is dispersed, spreading out in time and eventually overlapping with other messages. Since a laser produces a nearly pure wavelength, its light experiences little dispersion, an advantage over white light for transmission of information. In contrast, dispersion of electromagnetic waves coming to us from outer space can be used to determine the amount of matter they pass through. As with many phenomena, dispersion can be useful or a nuisance, depending on the situation and our human goals.
How does a lens form an image? See how light rays are refracted by a lens. Watch how the image changes when you adjust the focal length of the lens, move the object, move the lens, or move the screen.
1: (a) What is the ratio of the speed of red light to violet light in diamond, based on Table 2? (b) What is this ratio in polystyrene? (c) Which is more dispersive? 2: A beam of white light goes from air into water at an incident angle of [latex]\boldsymbol{75.0^{\circ}}[/latex]. At what angles are the red (660 nm) and violet (410 nm) parts of the light refracted? 3: By how much do the critical angles for red (660 nm) and violet (410 nm) light differ in a diamond surrounded by air? 4: (a) A narrow beam of light containing yellow (580 nm) and green (550 nm) wavelengths goes from polystyrene to air, striking the surface at a [latex]\boldsymbol{30.0^{\circ}}[/latex] incident angle. What is the angle between the colors when they emerge? (b) How far would they have to travel to be separated by 1.00 mm? 5: A parallel beam of light containing orange (610 nm) and violet (410 nm) wavelengths goes from fused quartz to water, striking the surface between them at a [latex]\boldsymbol{60.0^{\circ}}[/latex] incident angle. What is the angle between the two colors in water? 6: A ray of 610 nm light goes from air into fused quartz at an incident angle of [latex]\boldsymbol{55.0^{\circ}}[/latex]. At what incident angle must 470 nm light enter flint glass to have the same angle of refraction? 7: A narrow beam of light containing red (660 nm) and blue (470 nm) wavelengths travels from air through a 1.00 cm thick flat piece of crown glass and back to air again. The beam strikes at a [latex]\boldsymbol{30.0^{\circ}}[/latex] incident angle. (a) At what angles do the two colors emerge? (b) By what distance are the red and blue separated when they emerge? 8: A narrow beam of white light enters a prism made of crown glass at a [latex]\boldsymbol{45.0^{\circ}}[/latex] incident angle, as shown in Figure 7. At what angles, [latex]\boldsymbol{\theta _{\textbf{R}}}[/latex] and [latex]\boldsymbol{\theta _{\textbf{V}}}[/latex], do the red (660 nm) and violet (410 nm) components of the light emerge from the prism? dispersion spreading of white light into its full spectrum of wavelengths rainbow dispersion of sunlight into a continuous distribution of colors according to wavelength, produced by the refraction and reflection of sunlight by water droplets in the sky |
White light can disperse into a rainbow of different colors when it enters glass from air because:
Related Posts
Copyright © 2024 SignalDuo Inc.
